CM3-PANEL-U - Panel PC (USB version) with RPi CM3L
貼心æ醒
åŽŸå» é€²å£
å«æ¨¹èŽ“æ´¾ Compute module 3 Lite
https://www.acmesystems.it/CM3-PANEL_microsd
https://www.acmesystems.it/CM3-PANEL_howtos
https://www.ezsolutionkr.com/tft-lcd-kd070c-4-tp
https://www.acmesystems.it/www/CM3-PANEL/KDCTP070001A.pdf
產å“特色
Main features
800 x 480 pixel 7 inch TFT panel with 10 points capacitive touch
Socket for Raspberry Compute Module 3 normal or lite
MIPI connector for Raspberry Pi Camera
Placement for an USB WiFi module @ 2.4 GHz OR for an USB host connector
Placement for a Yarm radio module
Up to 24 GPIO lines available for extensions or
Lcd backlight control (-1 GPIO)
Camera led and camera shutdown control (-2 GPIO)
SPI bus (-5 GPIO)
Hardware PWM lines (-2 GPIO)
Serial line (-2 GPIO)
PCM line (-4 GPIO)
I2C bus (-2 GPIO)
Operating temperature: -20° - +70°
Raspberry Pi signals available on the rear pin strips:
On the bottom side are available two sets of 16x2 pin strip pitch 2.54mm on where is possible to plug an expansion board or two flat cables.
The number written near each pin on the silk screen indicates the GPIO number. The pin numbering starts from top left down to bottom right.
On each pin group are available the power supply lines (+5 volt, +3.3 volt and GND) and a set of GPIOs and control signals.
產å“è¦æ ¼